

It doesn’t work half the time.


Sure. Any suggestions for a rehost?
Like I wrote in the body.
Side note - anyone have a good video rehost other than catbox?
I had similar issues. Turns out I was using 70% ipa. Switching to 90% fixed it.


If you like logistics or problem solving, it’s addictive. I have 1200 hours in it.


Thanks for the tip


Upping the flow isn’t the problem then. In my experience, flow only ever varies between 95 and 105%. It’s there to compensate for thinner or thicker than expected filament. The under extrusion is caused by something else. Possibly a blockage, possibly to much drag. Pushing harder, aka more flow, might not help.


Or maybe you need worse tape.


Blech. I’ve not found a good video host. Catbox only works half the time. If you have any suggestions I’m open.


Here’s their link tree https://linktr.ee/TheKitKiln
Which leads to thangs https://thangs.com/designer/The Kit Kiln
Sure. Any suggestions for a rehost?
Like I wrote in the body.