Honestly I’d steer away from Elegoo nowadays. They’re not bad, but they’re hostile towards the open source community (It took a while to force them to release the code for the Centauri Carbon since they’re using a bastardized version of Klipper). I’ve only had Elegoo printers up until now, but I’d look elsewhere nowadays.
Ringing 100%. Need to do some Input Shaping tuning
Is that not what we were doing? I’m not disagreeing that it’s scummy that they’re installing unnecessary files, just speculating that’s it’s ineptitude rather than malicious. Hanlon’s Razor and all that. Considering the downvotes on my comment I may have misread your comment.
I imagine it’s more of a vibe-coded “make sure the end users have all the files they’ll need to be ready to go” prompt, and it’s Claude that “decided” to just have all the files from the get-go
I’d say both
Don’t let computers steal your imagination and creativity
Yup, changing out your extruder, even if to an identical one, changes the weight just enough to cause this. Input Shaping is indeed what you want to look for, it’ll be different depending on the printer. Some you have to adjust config files, some you can actually do in the slicer now.
I’d give OrcaSlicer a shot, it has some built-in tuning mechanisms
As long as the borders are printing you should be golden. Not something you’d want to to often of course, depending on the printer, since you might strain the hardware at the extreme edges
Regular superglue for placing magnets, I like 3DGloop for sticking prints together