I never has an original psp, but I had a psp-go. It was great! I primarily used it to emulate the nes and Genesis. Not many people liked the other slide out screen aesthetic but it was one of my favorite parts of the design. It reminded me of the Motorola sidekick.

Last I hear OnePlus was on the verge of collapse. Not because of this, but because of the mismanagement since carl left. It will probably be absorbed into oppo soon enough https://www.androidheadlines.com/exclusive-oneplus-collapse.

Fusion works flawlessly for me in winapps (and I’m sure winboat), but it is s-l-o-w. I probably need to figure out GPU passthrough and it might be bearable… But I haven’t had much time to dedicate figuring it out.

I had similar issues tho on a custom designed printer. The issue ultimately was the adhesive for the silicone heater for the bed was failing ans slowly delaminating from the bed. When I felt the heater it was plenty warm… But when I felt the center of the bed where it prints it was a lot cooler. I had to replace the whole heat pad. I don’t know what yours uses to heat the bed but my guess would be that it is also on the way out.

Underrated comment.

Exactly. I don’t know the expected life span of 3m 468mp but apparently I exceeded it in my environment and duty cycle. I’m still working on getting the residue off of the bed however, and I can say that where it stuck, and did not fail, it did an excellent job, even pulling off bits of silicone with the glue.

I have had it since probably 2018? It was one of the original x5sa kits. Honestly it has been a good platform to learn off of

Custom. It started life as a tronxy x5sa-400 but I think only 2 steppers and the frame are original still. I changed the bed to a 16"² *3/8 thick aluminum tool plate about 5 years ago. It always worked well for me. Unfortunately the silicone mat I used doesn’t seem to be made any more. I’m going to try one meant for a creality cr10 S4. I may have to re-machine the mounting holes for the thru holes on the mat tho.