Following for the iOS port

So I didn’t buy any new parts for my ender 3 pro but I had to print a few things before I could print with any kind of consistency.

1. Bed screw locks. My bed would drift away from where I leveled it. This would cause it to fail on larger prints a lot
2. A filament roller with bearings. The rolls always seemed to have trouble pulling filament
3. Direct drive (Satansa?) for the extruder so it didn’t need to push and pull through that long tube
4. I already had this but a spark plug feeler gauge and moving the zAxis is the what i’ve found to be the best way to level your bed. I like .7mm for this

All of these should probably work with yours, not sure if you still have it. If not make sure you have a caliper and make adjustments in your slicer or tinkercad or just do a lil post processing

Edit: Here are some links https://www.thingiverse.com/thing:5020676 Print in place bearings https://www.thingiverse.com/thing:6070269 Bed locks I use, recommend doing those first since that’ll make the most difference https://www.thingiverse.com/thing:4662728 https://www.thingiverse.com/thing:4555065 One of these should work, you just would need to remount your extruder that you have You want the bent feeler gauge type like this https://a.co/d/03e9xyxV so it’s easy to hold. Your local auto store should have it

IDK what to do about the gaslighting by Fox and right wing media… Too many people trust things without verification and it’s the reason our country is in such despair right now

Right on. Your opinion is better than mine. I’m not a school teacher.

Dunno Yeah I disagree with AI. I grew up without phones but they should not be used in schools.