Not quite sure what your concern is with the top fill pattern. It is a load-bearing part, so it kind of needs to be the way it is to retain the part coming out the other side. As far as the extruder exiting the perimeter of the model, I would remind you of the possibility of printing more than one model on a build plate. Although, I hadn’t yet considered trying to print only one to see if it still happens, as a troubleshooting approach. I’ll try that later, to rule out the possibility that it’s being mechanically pulled off by an extruder transport move.

It’s enclosed

I’d considered raising the temperature a little to get the perimeter to stick better to its neighbor, but I wasn’t sure if hotter printing would worsen the thermal contraction, which is what I was originally suspecting was happening. Nothing ever pulls off from an outer perimeter, it’s only inner perimeters of empty loops or holes.

It’s both first layers and higher. No pattern I can find. Bed adhesion is definitely fine, I haven’t had a single lifted corner since I started using the SuperTac plate.

It’s both first layers and higher. No pattern I can find. Bed adhesion is definitely fine, I haven’t had a single lifted corner since I started using the SuperTac plate.

What?

You’re using a lot of very loosely defined terms with a lot of certainty. Machine learning is AI, we just usually apply it to the more simple versions of it. Where do you personally draw the line? I fully understand the plethora of risks, downsides, and injustices that can potentially be involved in the matter, but I legitimately don’t understand the extremist level hatred that some people express to anything that could hold the title of AI. To me, it parallels with someone saying that they hate ionizing radiation. Frequently, it’s also bad, and your entirely reasonable to try and avoid it on a daily basis, but it also has many uses that are beneficial and life-saving.

Every last bit of it? What is your stance on use of AI for tasks such as data analysis of massive sets for scientific research, or procedural automation of massive operations?

So, just the right amount of safe then?

I’m assuming that if you know that, you probably also know what she does for a living now… And I also want to know that. Programmer? Porn? Paralegal? I can’t even take a guess that feels right.

Ya. It’s a joke, and that’s how jokes work. In this essay, I will explain, examine, and critique every known form of Homo sapiens humor.

In the beginning…

For the LULZ obviously.

Queen

deleted by creator

No. For the same reason that they didn’t demolish Auschwitz. We must learn from our follies, lest we repeat them.

Come over to Marblecake and I’ll explain.